Unipolar Corona Diffusion Charger for aerosols
Established in the marketplace, the Cambustion Unipolar Diffusion Aerosol Charger is a standalone product which places a high level of electrical charge on an aerosol. The UDAC is derived from the well established technology contained in Cambustion's DMS500, which was launched in 2002.
Second Generation UDAC
The UDAC incorporates a corona charger, allowing charging of aerosols to a much higher degree than is possible with other techniques such as radioactive or x-ray bipolar equilibrium charging.
The UDAC now incorporates selectable polarity as standard, together with reduced weight and size over the first generation.
The touchscreen interface and automatic computer control of relevant parameters, coupled with integrated diagnostic and warning capability make the UDAC a convenient building block in aerosol science experiments.
Use of multiple sheath flows of HEPA filtered air minimise particle losses inside the system.
A key application for the UDAC allows the generation of an aerosol of known mass concentration, for use as an aerosol mass calibration standard.
The interest in filtration efficiency of face coverings during the COVID 19 pandemic has seen the UDAC used to study the effect of particle charge on mask penetration.
Download a brochure, or contact Cambustion for further information and prices.
Need more information? Connect to an expert
Aerosol Flowmeter Accessory
Cambustion also offers an aerosol flowmeter accessory for the UDAC. This offers realtime measurement of the aerosol flow (via orifice delta P) and interfaces with the UDAC for power and data output.
Contact Cambustion for more information.
The DMS500 uses electrical mobility measurements to produce particle size / number spectra between 5 nanometres and 2.5 microns.